Checking the Damage Hardaware Computers

Computer units damage might happen. The cause can also be varied. Beginning with the hardware that this was time and energy to die, physically handicapped, konsleting and so forth.


Computer Hardware
Damage check we should know the way. For when there are problems using the pc, we could address alone. This is how to test computer hardware problem brought on by indication.

CPUs Total Death
1.
Confirm the electrical network, including power cable, cable jack and electrical networks. Ensure that all things are functioning properly. To test this don't use anything but test. Pen
2. When the normal electricity network,
examine the power. Could be the power remains to be alive. To check the capability supply on, or otherwise open my article How Easily Test Power.
3.
Look into the power cables connected to the motherboard. Ensure the power cable in the motherboard and processor power cable is installed.

CPU Life
However, there is No Display On Monitor
1.
Look at the monitor data cable is coupled to the CPU, sudap installed properly you aren't.
2. Listen to the sound generated by the
CPU. Usually if the CPU is mounted speaker identification, will issue a beep. To understand the damage by way of a beep of my articles go to Detect Destruction of Hardware Through Beep Beep.
3.
Return to RAM and VGA. Make sure it is installed properly.
4.
Ensure the processor power cable is installed. In any other case already installed the processor fan isn't working or otherwise not spinning.
5. If everything is installed properly
there is an chance for injury to the electricity supply. That output cannot meet the needs CPU power.

Blue Screen occurs
Blue screen
as soon as the computer is alive but then when going into the operating-system are not able to, just menambilkan blue screen along with a collection of error messages. This takes place as a consequence of problems for the memory bisasanya. Along with instability caused by memory, it can also be due to the difficult drive just isn't normal. It might happen bad sactor or harm to the disk partition.

Split-Split Image Display
Hardware damage
that occurs is on VGA. Seek to remove the VGA from your slot and clean of dust and clean the legs of VGA with the eraser. And then plug it in again.

Well here's
how to check the damage in a simple computing devices. Now you can do it. So from now on I have to go to a service person first, attempt to handle alone. In addition to personal savings could add to the experience.

Comments